.webp&w=3840&q=75)
Redevices in Longview TX
Every outlet. Every switch. Done right.
Complete replacement of all 120V receptacles and switches in Tyler, Longview & East Texas homes — plus correction of series wiring to parallel so a single bad device can't kill an entire circuit.
- Licensed & insured
- Same-day response
- Permit-pulled work
Redevices in Longview TX in Tyler, Longview & East Texas
Here's a pattern we see constantly in older East Texas homes: half the living room goes dead, the breaker never tripped, and the culprit turns out to be one worn-out receptacle three rooms away. That's series (daisy-chained, device-dependent) wiring — every downstream outlet depends on the cheap back-stab connections of the one before it. After fifty years of plugging and unplugging, those connections fail, and they sometimes fail hot.
A redevice fixes the whole problem in one pass. We replace every 120V receptacle and switch in the house with spec-grade, commercial-rated devices, correct the wiring at each box from series to parallel so every device stands on its own, and add the protection modern code expects — GFCI in kitchens, baths, and outdoors, AFCI where required, and tamper-resistant receptacles throughout. It's the single biggest reliability upgrade an older home can get without opening the walls for a full rewire.
It's also the honest middle option we quote a lot. If your home's wiring itself is sound copper but the devices are original, a redevice gets you most of the safety benefit at a fraction of a rewire's cost. We serve homeowners across Tyler, Longview, and the surrounding counties — and we'll tell you plainly which option your house needs after we've looked, not before.
Signs it's time
- One dead outlet takes out several others with it
- Plugs fall out of receptacles under their own weight
- Warm or discolored outlet and switch plates
- Crackling or intermittent power at certain outlets
- Original devices in a home that's 40+ years old
- No GFCI protection in kitchens, baths, or outdoors
Every wire,
every device.
Older homes are often wired in series — one bad outlet takes out the whole run. We replace every device, upgrade to spec-grade receptacles, and rewire from series to parallel so each device is independent.
- Full-home receptacle replacement
- Full-home switch replacement
- Series to parallel wiring correction
- GFCI protection where required
- AFCI protection where required
- Tamper-resistant receptacle upgrades
- USB-A/C combo outlet upgrades
- Device & circuit labeling
Four steps.
No games.
From the first phone call to the final walk-through, the process is the same every time. Predictable on purpose.
- 01
You call. We listen.
Tell us what's going on — we'll get the basics and schedule a time to come see it. No high-pressure salesman, no script.
- 02
We visit the job.
Accurate pricing starts with eyes on the work. We show up when we said we would, walk the site, and give you a flat, written price — no guesswork.
- 03
Work done right.
Permit-pulled, code-compliant, neat. Tidy job site every day. We label circuits, clean up, and walk you through what we did.
- 04
We stand behind it.
If something we installed fails — that's on us, period. Call and we make it right. That's the only deal we know how to offer.
The difference is
in the details.
Every outlet. Every switch. Done right.
- 01All receptacles & switches replaced
- 02Series → parallel wiring correction
- 03Eliminates single-device circuit failures
- 04Spec-grade, commercial-rated devices
Questions we
hear a lot.
Straight answers about redevices in longview tx — and if yours isn't here, call and ask. A real person picks up.
What exactly is series vs. parallel wiring, in plain English?
In series (daisy-chained through the device), power passes through each outlet on its way to the next — so one failed device cuts power to everything after it, like old Christmas lights. Corrected to parallel, each device connects independently to the circuit wiring, so a failure stays local. Most older homes were wired the fast way; we correct it at every box as we go.
How long does a whole-home redevice take?
Most homes take one to two days. We work room by room, keep the power on everywhere we're not actively working, and label as we go. You get a flat written price after we walk the house.
Is a redevice enough, or do I need a full rewire?
It depends on what's in the walls. Sound copper wiring with worn-out devices: redevice. Knob-and-tube, cloth insulation, or aluminum branch wiring: that's rewire territory, and new outlets on bad wire would be lipstick on a real problem. We check what's actually in your boxes before quoting either one.
What are spec-grade devices, and why do they matter?
They're the commercial-duty tier of receptacles and switches — heavier contacts, better clamping, rated for far more insertion cycles than the builder-grade devices most homes get. The cost difference per device is small; the difference in how they hold up over decades is not.
Will you add GFCI and AFCI protection during a redevice?
Yes — it's part of the scope. GFCI protection goes where water and ground contact make shocks dangerous (kitchens, baths, garages, exterior), and AFCI where code calls for arc-fault protection. We'll also flag anything at the panel that affects the plan, like missing grounding or surge protection.
A SW
5 days agoHighly recommend Chosen 1 Electric! Mark Reyes, the owner and a Master Electrician, was the only electrician I contacted who actually responded and followed through. I even had to cancel our original appointment the same day because of a family emergency, and he was incredibly understanding. When I rescheduled and explained I needed the work sooner, Mark fit me in. He and his assistant Abel didn’t just replace an outlet—they evaluated the existing setup, explained why we were having problems, identified what needed to be brought up to code, and gave us a practical solution so we could safely charge our car and connect our RV. Responsive, knowledgeable, professional, and dependable. Chosen 1 Electric is a newer local business, but Mark’s experience as a Master Electrician shows. I’ll absolutely call them again and highly recommend giving this local business an opportunity.
Sue Nolen
1 week agoMatt Yost
1 month agoI needed to have an RV plug installed in my garage and to also have a couple of ground fault outlets replaced. I was not sure who to call but after doing some online research I reached out to Chosen 1! Mark showed up exactly when he said he would and he completed the job quickly and professionally! I will definitely call him again with my electrical needs.
Andrea Webb
1 month agoI highly recommend this electrical company! It is so refreshing to find a company that is not only knowledgeable and reliable but also honest. Mark took the time to explain the issue, provided straightforward information, and did not try to pressure me into unnecessary repairs. The work was completly professionally, and I felt confident that I was being treated fairly. If you are looking for an electrician you can trust, I would definitely recommend them!
Jerry Gerber
1 month agoWhile we're
on the truck.
Most of our jobs touch more than one of these. If you need something we didn't list, just ask — odds are we do that too.
.webp&w=3840&q=75)
.webp&w=3840&q=75)
.webp&w=3840&q=75)
Redevices across East Texas.
Our truck rolls from Big Sandy to Tyler, TX and Longview, TX every week — plus the smaller towns in between. If you're anywhere in 4 counties of East Texas, you're in our service area. Need this in Houston, TX? Visit our sister shop.
Ready when
you are.
Tell us about the job — we'll come out, see it in person, and give you a straight, written price.